single-color controller --- LED Dim Controller
Product Speciality
¡ñ0-100% brightness control, 256 levels;
¡ñOn/off function;
¡ñ1 channel, can drive up to 10A;
¡ñ0%, 25%, 50%, 75%, 100% brightness pre-saved;
¡ñPre-saved fade, flash changing mode, 8 scale speed;
¡ñRemote control(Optional).
Appication Sites
¡ñBuilding Decoration: Business spaces, airports, subway;
¡ñIndoor Decoration: Lighting and back lighting for hospital, hotel, marketplace, square, dining-room, pub and etc.;
¡ñAD solid Word, sign and mark, signboard and billboard;
¡ñBe used as big area back lighting source.
Product Attributes
DC V_in |
12/24V |
I_out |
10A(Max) per channel, 12V: 120W; 24V: 240W |
Size |
211(L)X40(W)X30(H) mm |
Weight |
300g |
Change Mode Instruction
Mode |
Mode Description |
M1 |
0% |
M2 |
25% |
M3 |
50% |
M4 |
75% |
M5 |
100% |
M6 |
Flash |
M7 |
Fade |
Operation Instruction
ON/OFF: Press it to open or close the output
Mode: Press it to change the mode to next one£»
Brightness
While at M1-M5:
+: Press it to increase the brightness of the LED (Continous increase by long press);
- : Press it to decrease the brightness of the LED(Continous decrease by long press);
While at M6-M7:
+: Press it to make the change speed of the LED to a faster level;
- : Press it to make the change speed of the LED to a slower level.
Wiring Instruction
Remark:
Can control various single color modules.
Contents about install
(1)The input voltage should be limited in rated range.
(2)Do not use it by over load.
(3)Installed in suited environment.
(4)If the load line was too long, you should link it like a ring
Troubleshooting Guide
Problem |
Reason |
Solution |
1.All the lamps were off |
The power wire not connected well or no output |
Reconnect the power wire or change a power supply |
Lamp¡¯s power wire not connected well |
Reconnect the power wire |
2. Irregular flicker |
Line is too long or not connected well |
Shorten the line or add a amplifier |
|
